Custom camera strap DIY

how to customize the camera strap tutorial
It's time to make something easy, but very special! Follow the directions below to jazz up your own camera.


Supplies: 3 1/2 ft beaded trim, 4 ft twill tape, 2 D-rings, 2 metal clasps, E6000 glue




1. Glue the beaded trim directly in the center of the black trim. The trim is long, so you may have to glue it piece by piece. Let dry.
2. Slightly pull open the sides of the D-ring and slide the clasp onto the D-ring so they are connected.
3. Slide the D-ring onto the end of the black trim, leaving an inch or two on the end. Making sure the black trim is flipped over, (with the beaded trim on the bottom) apply some glue to the end of the trim and press it down over the D-ring. Hold in place until it dries. 
HandMadera note: I would also sew it to make it more secure.
4. Repeat step 2 and 3 for the other side of the strap. Hook the clasps onto your camera and you’re all set!



 Source: blog.mjtrim.com

No comments:

Post a Comment

Notes From Fabulouls People - Add Yours Here:

LinkWithin

Related Posts Plugin for WordPress, Blogger...